• Volume 4,Issue 1,2019 Table of Contents
    Select All
    Display Type: |
    • Model and application of renewable energyaccommodation capacity calculationconsidering utilization level of interprovincialtie-line

      2019, 4(1):1-12. DOI: 10.1186/s41601-019-0115-7

      Abstract (1681) HTML (0) PDF 1.52 M (1164) Comment (0) Favorites

      Abstract:At present, the problem of abandoning wind and PV power in “Three North” region of China is particularly significant, and how to alleviate this problem has become the focus of universal attention. Calculation of renewable energy accommodation capacity is the basis to solve the problem of abandoning wind and PV power. Main problems of Chinese renewable energy accommodation is analyzed from power supply, power grid and load side aspects, and it focuses on the effect of inter-provincial tie-line to renewable energy accommodation capacity. At present, the interprovincial tie-line utilization level is limited, which affected renewable energy accommodation to a certain extent. Based on the sequential production simulation model, a new kind of renewable energy accommodation capacity model is put forward considering the utilization level of inter-provincial tie-line. According to different system stability constraints and different electricity constraints of inter-provincial tie-line, 4 schemes are designed for comparative analysis, and the evaluation model is used to calculate renewable energy accommodation capacity of “Three North” region of China in 2020. Example analysis results verify validity of the model that releasing curve constraints, electricity constraints and stability constraints in turn can significantly enhance renewable energy accommodation capacity through effective use of inter-provincial tie-line transmission capacity. Research work in this paper can provide strong support for the planning and scheduling control of power grid.

    • Interconnected multi-machine powersystem stabilizer design using whaleoptimization algorithm

      2019, 4(1):13-23. DOI: 10.1186/s41601-019-0116-6

      Abstract (1874) HTML (0) PDF 2.43 M (934) Comment (0) Favorites

      Abstract:The role of Power System Stabilizer (PSS) in the power system is to provide necessary damping torque to the system in order to suppress the oscillations caused by a variety of disturbances that occur frequently and maintain the stability of the system. In this paper, a PSS design technique is proposed using Whale Optimization Algorithm (WOA) by considering eigenvalue objective function. Two bench mark multi machine test systems: three- generator nine- bus system, two- area four- generator inter connected system working on various operating conditions are considered as case studies and tested with the proposed technique. Extensive simulation results are obtained and effectiveness of proposed WOA-PSS are compared with well - known PSO and DE based stabilizers under several disturbances.

    • A critical fault detection analysis & faulttime in a UPFC transmission line

      2019, 4(1):24-33. DOI: 10.1186/s41601-019-0117-5

      Abstract (2063) HTML (0) PDF 1.74 M (974) Comment (0) Favorites

      Abstract:This paper discusses a critical study of fault detection and fault time analysis in a Unified Power Flow Controller (UPFC) transmission line. Here the Discrete Wavelet Transform (DWT) and Discrete Fourier Transform (DFT) approach are used for processing the faulty current signal to obtain fundamental current signal. The extracted fault current signals from the current transformer are fed to DWT and DFT approach for computing spectral energy (SE). The differential spectral energy (DSE) of phase currents are evaluated by taking the difference of SE obtained at sending and receiving end. The DSE is the key factor for deciding the fault in any of the phase or not. The Daubechy mother wavelet (db4) is used here because of its high accuracy of detection with less processing time. The novelty of the scheme is that it can accurately detect the critical fault variation of the line. Number of simulations are validated at the extreme condition of the line and compared to other conventional existing scheme. Multi-phase fault in double circuit line, CT saturation, UPFC operating condition (series voltage and angle), UPFC location and wind speed variation including wind farm simulation are validated to verify the performance of the scheme. The advantages of the scheme is that it works effectively to detect the fault at any stage of critical condition of the line and fault detection time remains within 20 msec (less than one cycle period). This scheme protects both internal and external zone including parameter variation of the line.

    • Modified vector controlled DFIG windenergy system based on barrier functionadaptive sliding mode control

      2019, 4(1):34-41. DOI: 10.1186/s41601-019-0119-3

      Abstract (1469) HTML (0) PDF 1.99 M (942) Comment (0) Favorites

      Abstract:Increased penetration of wind energy systems has serious concerns on power system stability. In spite of several advantages, doubly fed induction generator (DFIG) based wind energy systems are very sensitive to grid disturbances. DFIG system with conventional vector control is not robust to disturbances as it is based on PI controllers. The objective of this paper is to design a new vector control that is robust to external disturbances. To achieve this, inner current loop of the conventional vector control is replaced with sliding mode control. In order to avoid chattering effect and achieve finite time convergence, the control gains are selected based on positive semi-definite barrier function. The proposed barrier function adaptive sliding mode (BFASMC) is evaluated by testing it on a benchmark multi-machine power system model under various operating conditions. The simulated results show that the proposed method is robust to various disturbances.

    • Short-term interaction between electricvehicles and microgrid in decentralizedvehicle-to-grid control methods

      2019, 4(1):42-52. DOI: 10.1186/s41601-019-0118-4

      Abstract (1714) HTML (0) PDF 2.01 M (899) Comment (0) Favorites

      Abstract:In this paper, a particular standard MicroGrid (MG) is accurately simulated in the presence of the Electric Vehicles (EVs) participating in decentralized primary frequency control service. It examines effect of number of the participating EVs on the short-term dynamic behaviour. The simulation results confirm that frequency deviation will not definitely become zero even though an unlimited number of the EVs participate. The output power of each EV is determined according to the frequency deviation. On the other hand, the output power of each EV affects the value of the frequency deviation, especially in small-scale MGs and MGs with predominant inductance behaviour. Eventually, an equilibrium point is reached after a new EV is added that depends on the characteristics of the MG and the functions executed in the MG central controller during such a service. Additionally, effect of Reflex method, an advanced charging technique for EVs, on the frequency deviation is examined.

    • Wide area measurements based faultdetection and location method fortransmission lines

      2019, 4(1):53-64. DOI: 10.1186/s41601-019-0121-9

      Abstract (1763) HTML (0) PDF 1005.93 K (1005) Comment (0) Favorites

      Abstract:Electric power grids are critical infrastructure for delivering energy from generation stations to load centers. To maximize utilization of assets, it is desirable to increase the power transferred over transmission systems. Reliable protection of transmission systems is essential for safeguarding the integrity and reliability of the power grid. Distance protection is the most widely used scheme for protecting transmission lines. Most existing protection systems use local measurements to make a decision while pilot protection is used in some circumstances. Distance protection may fail under stressed operating conditions, which could lead to cascading faults. This paper proposes a system integrity protection scheme by utilizing wide area measurements. The scheme partitions the system into subnetworks or protection zones and employs current measurements to derive a fault identification vector indicating the faulted zone. Then the fault location is pinpointed based on wide area measurements and network data. The proposed method is able to deal with multiple, simultaneous faults, and is applicable to both transposed and untransposed lines. Evaluation studies based on simulation studies are presented.

    • Stability analysis and decentralizedcontrol of inverter-based ac microgrid

      2019, 4(1):65-86. DOI: 10.1186/s41601-019-0120-x

      Abstract (1962) HTML (0) PDF 3.15 M (978) Comment (0) Favorites

      Abstract:This work considers the problem of decentralized control of inverter-based ac micro-grid in different operation modes. The main objectives are to (i) design decentralized frequency and voltage controllers, to gather with power sharing, without information exchange between microsources (ii) design passive dynamic controllers which ensure stability of the entire microgrid system (iii) capture nonlinear, interconnected and large-scale dynamic of the micro-grid system withmeshed topology as a port-Hamiltonian formulation (iv) expand the property of shifted-energy function in the context of decentralized control of ac micro-grid (v) analysis of system stability in large signal point of view. More precisely, to deal with nonlinear, interconnected and large-scale structure of micro-grid systems, the port-Hamiltonian formulation is used to capture the dynamic of micro-grid components including microsource, distribution line and load dynamics as well as interconnection controllers. Furthermore, to deal with large signal stability problem of the microgrid system in the grid-connected and islanded conditions, the shifted-Hamiltonian energy function is served as a storage function to ensure incremental passivity and stability of the microgrid system. Moreover, it is shown that the aggregating of the microgrid dynamic and the decentralized controller dynamics satisfies the incremental passivity. Finally, the effectiveness of the proposed controllers is evaluated through simulation studies. The different scenarios including grid-connected and islanded modes as well as transition between both modes are simulated. The simulation conforms that the decentralized control dynamics are suited to achieve the desired objective of frequency synchronization, voltage control and power sharing in the grid-connected and islanded modes. The simulation results demonstrate the effectiveness of the proposed control strategy.

    • A survey on control issues in renewableenergy integration and microgrid

      2019, 4(1):87-113. DOI: 10.1186/s41601-019-0122-8

      Abstract (1728) HTML (0) PDF 4.01 M (1006) Comment (0) Favorites

      Abstract:This paper describes the usefulness of renewable energy throughout the world to generate power. Renewable energy adds a remarkable scope in power system. Renewable energy sources act as the prime mover of a microgrid. The Microgrid is a small network of power system with distributed generation (DG) units connected in parallel. The integration challenges of renewable energy sources and the control of microgrid are described in this paper. The varied nature of DG system produces voltage and frequency deviation. The unknown nature of the load produces un-modeled dynamics. This un-modeled dynamic introduces measurable effects on the performance of the microgrid. This paper investigates the performance of the microgrid against different scenarios. The voltage of the microgrid is controlled by using different controllers and their results are also investigated. The performance of controllers is investigated using MATLAB/Simulink SimPowerSystems.

  • Most Read
  • Most Cited
  • Most Downloaded
Press search
Search term
From To