引用本文:刘继,张小平,张瑞瑞.基于Buck-Boost矩阵变换器的异步电机调速系统控制策略[J].电力系统保护与控制,2019,47(20):156-162.
LIU Ji,ZHANG Xiaoping,ZHANG Ruirui.Control strategy of induction motor speed control system based on Buck-Boost matrix converter[J].Power System Protection and Control,2019,47(20):156-162
【打印本页】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 4911次   下载 2131 本文二维码信息
码上扫一扫!
分享到: 微信 更多
基于Buck-Boost矩阵变换器的异步电机调速系统控制策略
刘 继,张小平,张瑞瑞
(湖南科技大学海洋矿产资源探采装备与安全技术国家地方联合工程实验室,湖南 湘潭 411201)
摘要:
针对以Buck-Boost矩阵变换器(BBMC)为功率变换器的异步电机调速系统,提出一种基于有限时间控制的变频调速控制方法。首先,根据异步电机的给定转速,经基于PI-IP控制的矢量控制算法获得异步电机的给定电压,并以该给定电压作为BBMC的参考输出电压。再以BBMC中电容电压与电感电流作为系统控制变量,经有限时间控制算法得到BBMC中对应功率开关的占空比。再根据该占空比对BBMC中对应功率开关实施控制,由此可在BBMC输出端获得与其参考输出一致的输出电压,从而实现异步电机实际转速对其给定转速的准确跟踪,达到对异步电机转速进行准确控制的目的。最后通过仿真和实验对上述控制方法进行了验证。
关键词:  Buck-Boost矩阵变换器  异步电机调速系统  PI-IP控制  有限时间控制
DOI:10.19783/j.cnki.pspc.181432
分类号:
基金项目:国家自然科学基金项目资助(51477047)
Control strategy of induction motor speed control system based on Buck-Boost matrix converter
LIU Ji,ZHANG Xiaoping,ZHANG Ruirui
(National Union Engineering Laboratory of Marine Mineral Resources Exploration and Production Equipment and Safety Technology, Hunan University of Science and Technology, Xiangtan 411201, China)
Abstract:
Aiming at the asynchronous motor speed control system with Buck-Boost Matrix Converter (BBMC) as power converter, a frequency conversion speed control method based on finite time control is proposed. Firstly, according to the given speed of the asynchronous motor, the given voltage of the asynchronous motor is obtained by the vector control algorithm based on PI-IP, and the given voltage is used as the reference output voltage of the BBMC. Then the capacitive voltage and inductance current in BBMC are taken as the system control variables, and the duty cycle of the corresponding power switch in BBMC is obtained by the finite time control algorithm, and then the corresponding power in BBMC is opened according to the duty cycle. The output voltage which is consistent with its reference output can be obtained at the output end of BBMC, so that the accurate tracking of the actual speed of asynchronous motor to its given speed can be realized, and the purpose of accurate control of the speed of asynchronous motor can be achieved. Finally, the control method is verified by simulation and experiment. This work is supported by National Natural Science Foundation of China (No. 51477047).
Key words:  Buck-Boost matrix converter  asynchronous motor speed control system  PI-IP control  finite time control
  • 1
X关闭
  • 1
X关闭
引用本文:
【打印本页】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览次   下载  
分享到: 微信 更多
摘要:
关键词:  
DOI:
分类号:
基金项目:
Abstract:
Key words:  
  • 1
X关闭
  • 1
X关闭