基于IEC 61850的电动汽车充电站远动通信建模

黎永昌; 王钢; 梁远升; 曾德辉

引用本文:	黎永昌,王钢,梁远升,等.基于IEC 61850的电动汽车充电站远动通信建模[J].电力系统保护与控制,2016,44(4):137-142.
	LI Yongchang,WANG Gang,LIANG Yuansheng,et al.IEC61850-based electric vehicle charging station telecontrol communication information modeling[J].Power System Protection and Control,2016,44(4):137-142

【打印本页】【下载PDF全文】【查看/发表评论】【EndNote】【RefMan】【BibTex】

←前一篇|后一篇→

过刊浏览高级检索

本文已被：浏览 5898次下载 2856次	码上扫一扫！
分享到：微信更多字体:加大+\|默认\|缩小-
基于IEC 61850的电动汽车充电站远动通信建模
黎永昌, 王钢, 梁远升, 曾德辉
华南理工大学电力学院, 广东广州 510640

摘要:

为保障电动汽车充电站大规模接入情况下的配电网可靠稳定运行, 基于IEC61850标准展开电动汽车充电站与配电调度控制中心的远动通信建模研究? 依据典型电动汽车充电站的一次系统架构及通信系统构成, 提出了符合IEC61850标准的远动通信架构? 在分析总结电动汽车充电站远动通信需求的基础上，通过IEC61850-7-4以及IEC61850-7-420所定义逻辑节点构建远动通信模型? 搭建远动通信仿真平台进行测试，结果证明了该远动通信架构以及通信建模方案的有效性?

关键词: 电动汽车充电站 IEC 61850 远动通信建模

DOI：10.7667/PSPC150732

分类号:

基金项目:国家自然科学基金资助项目(51477057)

IEC61850-based electric vehicle charging station telecontrol communication information modeling

LI Yongchang, WANG Gang, LIANG Yuansheng, ZENG Dehui

School of Electric Power, South China University of Technology, Guangzhou 510640, China

Abstract:

To guarantee safe and reliable operation of distribution network in the case of electric vehicle charging stations increasing fast, this paper carries out research on electric vehicle charging station telecontrol communication modeling based on IEC 61850. It presents a telecontrol communication architecture that complies with IEC 61850, and summarizes its telecontrol communication information requirement. Then the telecontrol communication model construction is achieved through the use of logical nodes defined in IEC 61850-7-4 and IEC 61850-7-420. Finally, the communication architecture and model are verified on simulation platform. Result shows that the communication architecture and model is feasible.

Key words: electric vehicle charging station IEC 61850 telecontrol communication communication modeling

X关闭