| 引用本文: | 冯明,李兴源,李宽,等.多端柔性直流输电系统启动控制及其仿真[J].电力系统保护与控制,2013,41(14):60-65. |
| FENG Ming,LI Xing-yuan,LI Kuan,et al.Control and simulation of VSC-MTDC start-up procedure[J].Power System Protection and Control,2013,41(14):60-65 |
|
| 摘要: |
| 启动控制是多端柔性直流输电（VSC-MTDC）系统中重要的附加控制。合适的启动控制策略可以减小VSC-MTDC启动时产生的过电压和过电流，缓解其对交流电网和各个元器件的冲击，防止设备损坏。为此，首先分析了VSC-MTDC系统过电压过电流的形成原因，针对不同的启动阶段设计了适合于VSC-MTDC系统的启动控制策略，最后在PSCAD/EMTDC环境下建立了VSC-MTDC系统的模型，验证了设计的启动控制策略。仿真结果表明，该控制策略可以有效地抑制启动过程中的过电压和过电流，保证系统平稳地过渡到额定运行状态。 |
| 关键词: 电压源换流器 多端直流输电 启动控制 电容器充电 限流电阻 |
| DOI：10.7667/j.issn.1674-3415.2013.14.010 |
| 分类号: |
| 基金项目:国家自然科学基金重点项目（51037003）；国家电网公司科技项目资助 |
|
| Control and simulation of VSC-MTDC start-up procedure |
|
FENG Ming,LI Xing-yuan,LI Kuan,et al
|
| Abstract: |
| Start-up control is an important additional control in the system of multi-terminal HVDC based on voltage source converter (VSC-MTDC). Appropriate startup control can reduce the impact of over-voltages and over-currents on the AC grid, and avoid the damage to equipment. To this end, the analysis of the over-voltage and over-current causes has been done; and then a start-up control strategy which is suitable for the VSC-MTDC system has been designed; at last a VSC-MTDC system model has been built in the software PSCAD / EMTDC to verify the effectiveness of the procedure. Simulation results show that the control strategy can effectively restrict the over-voltage and over-current in the start-up process, which ensures the system’s smooth transition to its rated state. |
| Key words: voltage source converter(VSC) multi-terminal HVDC start-up control capacitor charging limit resistor |
